BT REFLEX RR B Service Manual page 452

41- 10
Positioning equipment – 9390
Programming
T-code
403-414, 669-671, 716-718
Date
2005-06-01
Leave level
• Pick up the load and wait three seconds. Lift the forks just enough so
that the load can be removed from the rack. Ensure that there is suf-
ficient space for safe handling.
• Now press the LEAVE button and both LEDs for collecting and leav-
ing will start to flash
• Press the PROG button until both LEDs go out and the display indi-
cates PL00, to save the information.
• Repeat from "LEAVE " level to program more levels.
• Press the STOP button to return to display mode.
41.9.2 Deleting programmed levels
Lower the forks to free lift level when deleting programmed lifting
heights.
• Enter programming mode and state the required level (e.g. 1+5=
level 15). The numbers are shown on the display.
• Press the COLLECT button (the LED flashes) and then press the
LEAVE button (both LEDs start to flash).
• Press the PROG button until both LEDs (COLLECT and LEAVE)
stop flashing and the display shows PL00 to erase the memory.
• Press the STOP button to return to display mode.
Service Manual REFLEX RR B,E RR B,E CC
https://www.forkliftpdfmanuals.com/
Valid from serial number
713962-
Order number
218920-040
..
© BT Europe AB