Cleaning And Washing - BT REFLEX RR B Service Manual

4- 2
Introduction, maintenance – P1

Cleaning and washing

T-code
403-414, 669-671, 716-718
Date
2005-06-01
• Discharge the system pressure slowly before starting work on the
truck's hydraulic system.
• Use paper or rigid cardboard when checking a possible oil leakage.
Never use your hands.
• Bear in mind that the oil in the transmission and the hydraulic system
may be hot.
WARNING !
Risk of burn injuries
Hot transmission and hydraulic oil.
Let the truck cool before changing the oil.
• Only fill the hydraulic system with new, clean oil.
WARNING !
The hydraulic system can be damaged.
Hydraulic components can be damaged, if the oil is contaminated.
Always use new, clean oil in the hydraulic system.
• Store and dispose of changed oil in accordance with local directives.
• Do not flush solvents and the like used for cleaning down drains that
are not intended for this purpose. Follow the local directives that ap-
ply for disposal.
• Disconnect the battery when welding on the truck.
NOTE!
The battery can be damaged.
When using electric welding equipment, the welding current can en-
ter the battery.
The battery must be disconnected.
• Remove at least 100 mm of paint around the welding/grinding area
by sand-blasting or the use of a paint stripper when welding or grind-
ing on painted surfaces.
CAUTION!
Unhealthy gases.
Heated paint gives off unhealthy gases.
Remove 100 mm of paint from around the working area.
4.2 Cleaning and washing
Cleaning and washing the truck is important for the reliability of the
truck.
• Carry out general cleaning and washing weekly.
NOTE!
Risk of short-circuiting.
The electrical system can be damaged.
Disconnect the battery before washing by pulling out the battery plug.
Service Manual REFLEX RR B,E RR B,E CC
https://www.forkliftpdfmanuals.com/
Valid from serial number
713962-
Order number
218920-040
© BT Europe AB