BT REFLEX RR B Service Manual page 350

32- 2
Reach cylinder – 6650
Dismantling
T-code
403-414, 669-671, 716-718
Date
2005-06-01
• Unscrew the hoses from the reach cylinder.
• Unscrew the upper left bolt on the protective plate.
• Unscrew the mounting bolts for the pins.
• Screw in a lifting eye of the like in the pins.
• Pull out the pins.
• Lift out the reach cylinder
32.3.1 Dismantling the cylinder
• Place the bottom stud in a vice and let the top section rest against
e.g. a pipe stand so that the cylinder lies in the horizontal position.
• Carefully knock the rod housing with a rubber mallet.
• Unscrew the rod housing using a pipe wrench.
• Carefully pull the rod out of the cylinder so that the threads are not
damaged. Place the rod on a soft and clean surface to prevent dam-
aged.
• Knock off the top sleeve using a rubber mallet.
32.3.2 Dismantle the rod seal and the support
ring.
• Knock a screwdriver in the rod seal without making any marks what-
soever on the ram.
NOTE!
If a ram is scratched it must be replaced to prevent leakage from oc-
curring.
• Very carefully lift up the rod seal.
• Carefully cut off the rod seal using a knife so that not damage is
caused to the ram.
• Remove the support ring.
32.3.3 Assembling the rod seal and the
support ring.
• Assemble the support ring and rod seal on the piston.
Service Manual REFLEX RR B/E, RR B/E CC
https://www.forkliftpdfmanuals.com/
Valid from serial number
713962-
Order number
218920-040
© BT Europe AB