Cab Tilting - BT REFLEX RR B Service Manual

© BT Europe AB
Introduction, maintenance – P1

Cab tilting

Valid from serial number
713962-
Order number
218920-040
4.5 Cab tilting
4.5.1 RR E 1-8
1
Make sure there is sufficient room for the tilted cab before you start
servicing work. Also make sure there is no risk of the cab accidentally
being tilted back during servicing.
On trucks with low lifting heights – extend the mast so that finger pro-
tection and panel are accessible when tilting up. Also check that the
cab does not catch the mast, hose reel or other parts on the truck.
WARNING!
Risk of being crushed.
There is a great risk of injury if anyone is present in the motor com-
partment when tilting the cab back.
Ensure no one is in the motor compartment when tilting the cab.
When you carry out a service in the motor compartment you should tilt
the cab fully. Only the lift/lower function is operational and then only at
crawl speed during tilting.
• Press the switch to lower the cab while starting the truck. The dis-
play shows 6 lines.
• Move the hydraulic lever for fork lift backwards.
• When the cab stops (at 15°), loosen the catch that releases the cab.
• Continue to move the lever backwards until the cab stops
(at 45°).
WARNING!
Falling cab!
The cab can fall without dampening when tilted over 45°.
The cab is heavy so make sure the person catching it has the situa-
tion under control. If possible, use an overhead crane.
• Take hold of the protective roof and tilt the cab fully.
• Insert the safety pin into the cylinder.
WARNING!
Risk of being crushed.
There is a great risk of injury if anyone is present in the motor com-
partment when tilting the cab back.
The safety pin must always be inserted.
Ensure nobody is present in the motor compartment when tilting the
cab back.
WARNING!
Risk of being crushed.
There is a great risk of injury if anyone is present in the motor com-
partment when tilting the cab back.
Ensure no one is in the motor compartment when tilting the cab.
Service Manual
https://www.forkliftpdfmanuals.com/
REFLEX RR B,E RR B,E CC
T-code
403-414, 669-671, 716-718
Date
2005-06-01
4- 5