Leakage From The Upper Cover; Leakage From The Lower Cover - BT REFLEX RR B Service Manual

© BT Europe AB
Mechanical drive gear unit – 2550
Repairs
Valid from serial number
713962-
Order number
218920-040

13.5.2 Leakage from the upper cover

Follow instructions below in the event of leakage from the transmis-
sion's upper cowl:
• Remove the transmission from the truck as described in the section
"Replacing the drive motor/drive transmission"
• Loosen all bolts holding the upper cowl on the transmission housing.
• Remove the cover from the transmission housing and clean the
sealant surfaces carefully, both on the cowl and the transmission
housing.
• Apply sealant such as Curil K2 to the surfaces. Follow the instruc-
tions on the package.
• Fit the cover and tighten the bolts to a torque of 46 Nm.
The bolts should be greased prior to assembly.
• Fill with oil as set out in the instructions for refilling.
• Assemble the drive transmission/drive motor and fit the drive as-
sembly in the truck as described in the section "Replacing the drive
motor/drive transmission."

13.5.3 Leakage from the lower cover

• Drain the remaining oil from the transmission.
• Dismantle the cover from the transmission.
• Replace the sealing ring on the drainage plug and the O-ring on the
cover.
• Mount the cover and tighten the bolts to a torque of 25 Nm. Make
sure the O-ring is not damaged. The bolts should be greased before
assembly.
Service Manual
https://www.forkliftpdfmanuals.com/
REFLEX RR B/E, RR B/E CC
T-code
403-414, 669-671, 716-718
Date
2005-06-01
13- 11