BT REFLEX RR B Service Manual page 355

© BT Europe AB
Tilt cylinder – 6660.1
Mast with valve on the fork carriage
Valid from serial number
713962-
Order number
218920-040
33.2.2 Dismantling the cylinder
• Unscrew the bolts (16).
• Carefully pull the rod out of the cylinder so that the threads are not
damaged. Place the rod on a soft and clean surface to prevent dam-
aged.
.
33.2.3 Dismantling the rod seal
• Knock a screwdriver in the rod seal without making any marks what-
soever on the ram.
NOTE!
If a ram is scratched it must be replaced to
prevent leakage from occurring.
• Very carefully lift up the rod seal.
• Carefully cut off the rod seal using a knife so that not damage is
caused to the ram.
33.2.4 Dismantling the ram
• Remove the rod seal.
• Knock and heat the ram a little, if necessary.
• Unscrew the ram (3) using pipe wrench 08-15393.
• Brush off any old flange sealant.
33.2.5 Assembling the ram
• Apply OMNI 230 on the thread.
• Screw in the ram using a hook spanner.
• Take care to wipe off all surplus sealant.
Service Manual
https://www.forkliftpdfmanuals.com/
REFLEX RR B/E, RR B/E CC
T-code
403-414, 669-671, 716-718
Date
2005-06-01
33- 3