BT REFLEX RR B Service Manual page 221

© BT Europe AB
Electronic card – 5710
Displaying and programming
Valid from serial number
713962-
Order number
218920-040
Clock
When the clock can be set, the hours will blink in the display, and after
depressing the travel direction selector, the minutes will blink.
• Use the lift/lowering lever to increase/decrease the value.
• Use the travel direction selector to switch between hours and min-
utes.
Function
hours
minutes
Complete programming and store the set value by depressing the red 0
key.
NOTE:
Altered truck characteristics.
If you alter truck-specific parameters, truck handling will change.
Do not change any parameters unless you have the necessary skills
to do so.
Driver parameters 1-7
Do as follows to reprogram the driver parameters if this is permitted:
• Enter the driver PIN-code and then depress the green I key on the
keypad so that the electronic card will recieve positive feed, at the
same time push the travel direction selector in the fork direction.
• Release the travel direction selector when "P" is displayed. The driv-
er number will be shown in the display (E).
• Use the lift/lowering lever to scroll to the parameter to be changed.
• Depress the travel direction selector (the parameter number blinks).
• Use the lift/lowering lever to increase/decrease the value.
• Depress the travel direction selector to confirm the value. (The pa-
rameter number stops blinking.)
To change other parameters, scroll to the desired parameter with the
lift/lowering lever and then repeat the operation "Depress switch I (the
parameter number blinks)".
Complete programming and store the set value by depressing the red 0
key.
Common driver parameters can only be reprogrammed using a service
instrument.
Service Manual
https://www.forkliftpdfmanuals.com/
Value
09 = 9h
35 = 35 min
REFLEX RR B/E, RR B/E CC
T-code
403-414, 669-671, 716-718
Date
2005-06-01
24- 9