Dismantling/Assembling The Wheel Bearings; Mm Wheel And 300 Mm Wheel Without; Dismantling The Bearing; Assembling Bearings - BT REFLEX RR B Service Manual

© BT Europe AB
Fork/support arm wheel – 3550.1

Dismantling/assembling the wheel bearings

Valid from serial number
713962-
Order number
218920-040
17.4 Dismantling/assembling the wheel
bearings
17.4.1 265 mm wheel and 300 mm wheel
without brakes.

Dismantling the bearing

• Remove the spacers (1).
• Remove the retainer rings (2).
• Press out the sleeve (3).
• Use a "soft" brass punch or similar to knock out the bearings (4).

Assembling bearings

• Press in the bearings (4). Use an assembly sleeve of the same out-
side diameter as the bearing's outer ring, 90 mm.
• Check that the sleeve (3) is not damaged.
• Fit one of the retainer rings (2) on the sleeve.
• Press in the sleeve until the retainer ring stops against the bearing.
• Fit the other retainer ring.
• Place the spacers (1) in position on the hub.
Service Manual
https://www.forkliftpdfmanuals.com/
REFLEX RR B,E RR B,E CC
T-code
403-414, 669-671, 716-718
Date
2005-06-01
17- 5