BT REFLEX RR B Service Manual page 314

Function
Pushbutton 0-9 is used
Log-out
Relay in keypad is closed
Incorrect driver PIN-code designated
Function
Keypad in programming mode
Pushbutton 0-9 is used
Correct value designated
Incorrect value designated
25- 102
Keypad
Programming
T-code
403-414, 669-671, 716-718
Date
2005-06-01
25.3.4 Function 3
• Connection 1 and 2 (X3:5, X3:9) is connected to system negative.
• Test function for relay
Designate the code 1234567890 and green pushbutton to close the
relay in the keypad.
• Open the relay with red pushbutton
Not. 1 If the service CAN-key is used at log-in no driver PIN-code is
necessary to designate.
25.4 Programming
25.4.1 LED status
Log-in
At programming
Service Manual REFLEX RR B/E, RR B/E CC
https://www.forkliftpdfmanuals.com/
Valid from serial number
713962-
Order number
218920-040
Green LED
Illuminate when pushbutton is
depressed.
Illuminates with brightness.
Green LED
Illuminates for ~0,8 seconds
and then flashes with interval
of 2 seconds.
Illuminates when pushbutton
is depressed.
Illuminates ~0,8 sek
Red LED
Illuminates ~0,8
sek
Illuminates ~0,8
sek
Red LED
Illuminates ~0,8
sek
© BT Europe AB