Introduction, Maintenance - P1; Safety Regulations During Maintenance Work - BT REFLEX RR B Service Manual

© BT Europe AB
Introduction, maintenance – P1

Safety regulations during maintenance work

Valid from serial number
713962-
Order number
218920-040
4- Introduction, maintenance – P1
All points in the service program shall be included to attain the highest
level of safety and minimum possible truck downtime. The service inter-
vals are for guidance only and do not need to be followed strictly. The
truck driver can adapt these to local conditions, but it is important that
the intervals meet the truck manufacturer's minimum requirements.
The service intervals are based on the operating times and can be
adapted to most normal 8 hour shifts. The service interval may be
shortened if the truck is used more frequently or in more demanding sit-
uations, e.g. cold store, dusty or corrosive environments. The following
operating hours have been used when calculating the interval:
Day time: 08.00-17.00 (20 hours/week)
2-shifts: 06.00-14.00, 14.00-22.00 (40 hours/week)
3-shifts: 06.00-14.00, 14.00-22.00, 22.00-06.00
(60 hours/week)
Ensure the truck receives a regular maintenance service after every
500 driving hours. The truck's safety, efficiency and service life is
dependent on the service and maintenance it receives.
Only use spare parts approved by the truck manufacturer for servicing
and repairs.
4.1 Safety regulations during
maintenance work
Only persons trained in servicing and repairing this type of truck are
qualified to carry out service and repair work.
• Do not carry out any maintenance work on the truck unless you have
the correct training and knowledge to do so.
• Keep the area where servicing work is done clean. Oil or water
makes the floor slippery
• Never wear loose objects or jewellery when working on the truck.
WARNING !
Short circuit/Burns
Short-circuiting and burn injuries can occur if metal objects come
into contact with live electrical connections when working on the
truck's electrical system.
Remove watches, rings and other metal jewellery.
• Always remove the battery plug when carrying out maintenance
work on the truck unless otherwise stated in this Service Manual.
• Always switch off the truck's power supply before opening the cov-
ers on the drive unit or electrical system.
Service Manual
https://www.forkliftpdfmanuals.com/
REFLEX RR B,E RR B,E CC
T-code
403-414, 669-671, 716-718
Date
2005-06-01
4- 1