BT REFLEX RR B Service Manual page 351

© BT Europe AB
Reach cylinder – 6650
Assembling
Valid from serial number
713962-
Order number
218920-040
32.3.4 Dismantling the ram
• Remove the rod seal and the support ring.
• Knock and heat the ram a little, if necessary.
• Unscrew the ram using a pipe wrench.
• Brush off any old flange sealant.
32.3.5 Assembling the ram
• Apply OMNI 230 on the thread.
• Screw in the ram using a hook spanner.
• Take care to wipe off all surplus sealant.
32.3.6 Assembling the cylinder
• Insert the rod in the cylinder.
• Knock the top sleeve in position on the rod using a rubber
mallet.
• Screw the top sleeve in the cylinder a few turns.
• Apply flange sealant FD 1042 on the thread.
• Tighten using a hook spanner.
• Assemble the cylinder in the truck.
NOTE!
The curing time for the flange sealant is 4 hours and the cylinders
must not be used before this.
32.4 Assembling
• Fit the reach cylinder.
• Knock in the pins.
• Screw in the mounting bolts for the pins.
• Bolt the protective plate in position.
• Fit the connectors X18 and X19 in the connector plate.
• Assemble the hoses on the cylinder.
• Fit the return hose on the tank.
Service Manual
https://www.forkliftpdfmanuals.com/
REFLEX RR B/E, RR B/E CC
T-code
403-414, 669-671, 716-718
Date
2005-06-01
32- 3