BT REFLEX RR B Service Manual page 377

© BT Europe AB
Main mast –7100
Assembly
Valid from serial number
713962-
Order number
218920-040
• Measure and shim as set out in the instructions above.
• Fit the fork carriage on the mast.
• Measure and shim as set out in the instructions above.
35.6.2 Radial play
• The play between roller and contact surface on respective beams
must not exceed 0.4 mm. Check using feeler gauges. If the play is
greater, the rollers must be replaced with oversized rollers. Over-
sized rollers (classified) are available in increments of 0.4 mm.
• When fitting oversized rollers, the play may be <0, provided that the
mast can be pushed together/drawn apart by hand, even if difficult.
After a short period of use, the rollers will give an imprint of the con-
tact surface as play > 0.
35.7 Assembly
• Fit:
- Free lift chain.
- Any chain guard.
- The main lift cylinders.
- The main lift chain sprockets.
- The main lift chains.
- Twin hose, cable and connector X50 in the fork carriage.
- Twin hose reel on the free lift cylinder.
- Manifold block with feeder hose on the feeder pipe to the main lift
cylinders.
- Feeder hose bracket on inner guide.
NOTE!
The triple hose can separate.
Risk that the triple hose may break.
Make sure the triple hose rollers are in line.
• Fit the mast in the truck.
Service Manual
https://www.forkliftpdfmanuals.com/
REFLEX RR B,E RR B,E CC
T-code
403-414, 669-671, 716-718
Date
2005-06-01
35- 13