Installing The Drive Motor; Assembling The Gear Wheel - BT REFLEX RR B Service Manual

29
27
62
54
© BT Europe AB
Mechanical drive gear unit – 2550
Replacing the drive motor/drive transmission
Valid from serial number
713962-
Order number
218920-040
• Screw in the centred steering indicator (8) so that it bottoms on the
edge. Then turn it back 1 1/2 turns and lock it in place with a lock nut.
• Screw in the steering wheel direction indicator (9) (red indicator di-
odes towards the battery compartment) until it stops, then turn it
back 1 1/4 turns and lock it in place with a lock nut.

13.3.5 Installing the drive motor

If you replaced the drive transmission (17), also replace the gear wheel
(51) on the drive motor.
If you replaced the drive motor, use the old gear wheel on the new
motor.

13.3.6 Assembling the gear wheel

• Replace the bearing cage (29) on the motor axle.
• Fit the circlip (27).
• Fit the key (7).
• Replace the gear wheel (51).
7
• Fit a new nut (54).
• Use tool 10-15639 and tighten to a torque of 60 Nm.
51
• Lock the nut with a centre punch in the keyway.
• Attach a lifting eye to the motor axle and lift into the transmission us-
ing an overhead crane.
NOTE!
Risk of damaging the gear wheel (A).
The gear wheel on the end of the motor is easily damaged.
Carefully lift in the motor.
• Secure the motor (61) in the transmission with a torque of 20 Nm.
• Reconnect the temperature, braking, and the speed measurement
contacts (14, 31) and power cables (60) to the motor.
• Remove the lifting eye bolt.
• Brake adjustment, see C-code 3100.
Service Manual
https://www.forkliftpdfmanuals.com/
REFLEX RR B/E, RR B/E CC
T-code
403-414, 669-671, 716-718
Date
2005-06-01
13- 7