BT REFLEX RR B Service Manual page 106

29
27
62
55 6 33
16
12- 2
Electric drive motor – 1760
Dismantling and assembling the drive motor
T-code
403-414, 669-671, 716-718
Date
2005-06-01
12.3 Dismantling and assembling the
drive motor
To open and close the motor compartment, see section P1 in this manual.
63
14
31
12.3.1 Dismantling the drive motor
60
• Cut the power by turning off the key and removing the battery plug.
• Remove the temperature, braking and speed measurement con-
61
tacts (14, 31, 63) and power cables (60) from the motor (61).
• Fasten a lifting eye to the motor axle.
• Loosen and remove the motor mounting bolts (62).
• Lift out the motor using an overhead crane and place it on a clean
surface.
NOTE:
Risk of damage to the gear wheel (51).
The gear wheel on the end of the motor is easily damaged.
7
Lift out the motor with care.
• Cover the hole to the transmission when the motor is removed to
51
prevent anything from falling inside the transmission housing.
54
Removing the gear wheel
• Tap loose the nut (54) and unscrew it using tool 10-15639.
• Pull off the gear wheel (51) using a gear puller.
• Remove the key (7) holding the gear wheel (51) in place.
37 • Remove the circlip (27) holding the bearing bracket (29) in place.
• Pull off the bearing bracket (29) using a gear puller.
Removing the brakes
• Loosen the screws (37) so that the brakes (33) can be removed.
• Remove the outer circlip (16) from the motor axle.
• Remove the brake hub, key (6), plate and inner circlip (16).
Service Manual
https://www.forkliftpdfmanuals.com/
Valid from serial number
713962-
Order number
218920-040
REFLEX RR B/E, RR B/E CC © BT Europe AB