BT REFLEX RR B Service Manual page 150

17- 4
Fork/support arm wheel – 3550.1
Assembling the wheel
T-code
403-414, 669-671, 716-718
Date
2005-06-01
• To centre the wheel vertically, use a jack to adjust the height of the
support arm.
• Check that the wheel axle (3) is not damaged. Minor longitudinal
scratches can be tolerated.
If the axle ends have been damaged, the axle should be ground or
replaced.
• Fit a new clamping ring (2) on the wheel axle (3).
WARNING !
Loose wheel.
If the wheel is refitted using the old clamping ring, the wheel can be-
come loose while driving.
Always fit the wheel with a new clamping ring on the wheel axle.
• Fit the extension punch on tool 08-13585 and insert it through the
wheel hub and support arm.
• Secure the wheel axle using the punch and carefully insert the axle.
Make sure the axle is not inserted too far. When the axle is correctly
positioned it should be centred in the support arm's wheel bracket.
• Lower the truck.
For wheels with brakes
• Tighten the locking bolt for the brake's locking shoe and connect the
brake cable. Secure the cable with a tie on the guard plate bracket
so that it does not rub against the wheel.
• Fit the cover plate.
Service Manual REFLEX RR B,E RR B,E CC
https://www.forkliftpdfmanuals.com/
Valid from serial number
713962-
Order number
218920-040
© BT Europe AB