BT REFLEX RR B Service Manual page 220

A B C
F G H I
24- 8
Electronic card – 5710
Displaying and programming
T-code
403-414, 669-671, 716-718
Date
2005-06-01
24.4 Displaying and programming
D E
It is possible to look up items in the machine-specific register, but not to
reprogram it. It is possible, however, to program driver-specific param-
eters and set the clock. The parameters are indicated in the table.
If the driver has not logged out with the 0 key, the truck will automatical-
ly perform the log-out operation after a specified time.
J K
.
24.4.1 Keypad
Do as follows to check the driver and machine-specific register set-
tings:
• Enter the driver PIN-code and then depress the green I key on the
keypad so that the electronic card will recieve positive feed, at the
same time push the travel direction selector in the fork direction.
The following functions will scroll across the display:
• Time of day
• Parameters
• Serial number of software Pn
• Operating hours
• Error codes
Release the travel direction selector at the desired item.
Use the lift/lowering lever to increase/decrease the value.
The travel direction selector is used for the different adjustment modes.
The display shows the following functions:
- (C) Time of day
- (D) parameters, serial number of software, operating hours and
error codes
The "No." of the address register is displayed on the left side, while the
"value" is displayed on the right side.
Service Manual
https://www.forkliftpdfmanuals.com/
Valid from serial number
713962-
Order number
218920-040
CL
P
H
E
REFLEX RR B/E, RR B/E CC © BT Europe AB