Rr E 2-8 Cc - BT REFLEX RR B Service Manual

4- 6
Introduction, maintenance – P1
Cab tilting
T-code
403-414, 669-671, 716-718
Date
2005-06-01
• Take hold of the protective roof and tilt the cab back to the 45° posi-
tion.
• Move the hydraulic lever for fork lift forwards until the cab comes to
rest in the lowered position.
WARNING!
Risk of tipping.
The truck can tip if the battery is removed when the truck is tilted to
the service position.
Never remove the battery from the truck.
NOTE!
Risk of being crushed.
The plastic guard can be damaged when tilting the cab down.
Always have the doorplate swung out when lowering the cab.
• Close the doorplate and tighten the screw for door locking.

4.5.2 RR E 2-8 CC

Make sure there is sufficient room for the tilted cab before you start
servicing work. Also make sure there is no risk of the cab accidentally
being tilted back during servicing.
WARNING!
Risk of being crushed.
There is a great risk of injury if anyone is present in the motor com-
partment when tilting the cab back.
Ensure no one is in the motor compartment when tilting the cab.
When you carry out a service in the motor compartment you should tilt
the cab fully. Only the lift/lower function is operational and then only at
crawl speed during tilting.
• Fit the tool 08-15912 between the lock function in the door and the
wall; this will keep the door open while tilting the cab.
• Press the switch for cab lowering while turning the key. The display
shows 6 lines.
• Move the hydraulic lever for fork lift backwards.
• When the cab stops (at 15°), loosen the catch that releases the cab.
• Continue to move the lever backwards until the cab stops
(at 45°).
Service Manual REFLEX RR B,E RR B,E CC
https://www.forkliftpdfmanuals.com/
Valid from serial number
713962-
Order number
218920-040
© BT Europe AB