BT REFLEX RR B Service Manual page 340

1
30- 2
Main lift cylinder – 6610
Dismantling the lift cylinders from the mast
T-code
403-414, 669-671, 716-718
Date
2005-06-01
30.3 Dismantling the lift cylinders from
the mast
• Loosen the lift chain from the top on the lift cylinder to be dismantled
and place it on the floor over the reach carriage.
• Remove the lifting chain sprocket.
• Block both inner runners approximately 50 cm above the floor with
blocks.
• Lower the free liftcylinder to the bottom.
• Loosen the connection pipe in the lift cylinder and manifold. The cyl-
inder can now be removed.
• Plug the manifold connections.
• Check that the remaining lift chains are not damaged.
• Check that the lift chains are not damaged or damage anything while
you raise the mast to the top.
• Loosen the lift cylinder by the bottom stud.
• Loosen the cylinder support at the top.
• Remove the cylinder from the mast.
30.4 Dismantling the cylinder
• Dismantle the cylinder from the mast.
2 3
• Place the bottom stud (9) in a vice and let the top section rest against
e.g. a pipe stand so that the cylinder lies in the horizontal position.
• Carefully knock the top sleeve and the cylinder with a rubber mallet,
carefully heat if necessary.
• Loosen the top sleeve (1) using tool 08-15393.
• Carefully pull the rod out of the cylinder so that the threads are not dam-
aged. Place the rod on a soft and clean surface so that it is not damaged.
• Knock off the top sleeve (1) using a rubber mallet.
Service Manual
https://www.forkliftpdfmanuals.com/
Valid from serial number
713962-
Order number
218920-040
4
REFLEX RR B/E, RR B/E CC
5 6 7 8 9 10
© BT Europe AB