BT REFLEX RR B Service Manual page 331

© BT Europe AB
Hydraulic pump – 6140
General
Valid from serial number
713962-
Order number
218920-040
27- Hydraulic pump – 6140
27.1 General
There is one pump size in the truck that has a max flow of 60 litres per
minute.
The pump motor is available in two sizes on the trucks.
P150 is used on B/E1-B/E6.
P195 is used on B/E7-B/E8
These service instructions contain a description on how to replace the
hydraulic pump.
27.2 Replacing the hydraulic pump
3
To open and close the motor compartment, see section P1 in this man-
ual.
6
7
27.2.1 Dismantling
12
• Disconnect the battery plug.
4
• Drop the forks to the lowest position to reduce pressure in the hoses
and pump.
• Pump the oil out of the hydraulic tank 3 with filter pump V10-15191.
• Remove the support (4) so that the bolts (5) for the pump mounting
(12) are accessible.
• Remove the temperature/speed measuring contacts (6) and power
cables (7) from the pump motor (8).
• Remove the hydraulic hose (9) and loosen the hose clamp for the
hydraulic hose (10) attached to the tank.
• Fasten a lifting eye in the motor axle.
• Remove the bolts (5) holding the pump mounting (12) to the chassis.
• Lift out the hydraulic pump and place it on a clean surface.
• Remove both mountings (12) from the pump motor (8).
• Remove the hose coupling from the pump unit (13).
• Remove the screws and dismount the pump (13).
• Remove the carrier.
Service Manual
https://www.forkliftpdfmanuals.com/
REFLEX RR B/E, RR B/E CC
T-code
403-414, 669-671, 716-718
Date
2005-06-01
27- 1