Drive Wheel - 3530; General; Dismantling The Drive Wheel; Assembling The Drive Wheel - BT REFLEX RR B Service Manual

© BT Europe AB
Drive wheel – 3530

General

Valid from serial number
713962-
Order number
218920-040
16- Drive wheel – 3530
16.1 General
The drive wheel consists of a cast rim with a vulcanised tread. When
changing the drive wheel you must ensure that you tighten the wheel
nuts to the correct torque.
On the Reflex truck two different sizes of wheel have been used.
One with the dimensions diameter 310x12 mm and one 350x130 mm.
The smaller wheel (310 mm) is used on B/E1- B/E3.
The larger wheel (350 mm) is used on B/E4 - B/E8.

16.2 Dismantling the drive wheel

• Lift up the truck on blocks so that the drive wheel is off the ground.
• Unscrew the four bolts holding the guard plate.
• Remove the guard plate.
• Unscrew the nuts holding the drive wheel in position.
• Lift off the drive wheel.

16.3 Assembling the drive wheel

• Lift on the new drive wheel.
• Apply MOLYKOTE grease BT number 055-73040 on the wheel bolts.
• Position the spherical washers (1) on the wheel bolts.
• Tighten the wheel nuts (2) to 130 Nm.
• Fit the guard plate.
• Remove the blocks.
Service Manual
https://www.forkliftpdfmanuals.com/
REFLEX RR B/E, RR B/E CC
T-code
403-414, 669-671, 716-718
Date
2005-06-01
16- 1