Replacing The Drive Motor/Drive Transmission; Dismantling The Drive Motor; Dismantling The Gear Wheel - BT REFLEX RR B Service Manual

29
27
62
© BT Europe AB
Mechanical drive gear unit – 2550

Replacing the drive motor/drive transmission

Valid from serial number
713962-
Order number
218920-040
13.3 Replacing the drive motor/drive
63
14
transmission
31
60
To open and close the motor compartment, see section P1 in this man-
ual.
61

13.3.1 Dismantling the drive motor

• Cut the power by turning off the key and removing the battery plug.
• Remove the temperature, braking and speed measurement con-
tacts (14, 31, 63) and power cables (60) from the motor (61).
• Fasten a lifting eye in the motor axle.
• Dismantle the motor's mounting bolts (62).
• Lift out the motor using an overhead crane and place it on a clean
surface.
NOTE!
Risk of damage to the gear wheel (A).
The gear wheel on the end of the motor is easily damaged.
Carefully lift out the motor.
• Cover the hole in the transmission when the motor has been removed
to prevent anything from falling inside the transmission housing.

13.3.2 Dismantling the gear wheel

• Tap out the nut (54) lock and unscrew the nut using tool 10-
1515639.
• Pull off the gear wheel (51) using a puller.
7
• Remove the key (7) holding the gear wheel (51) in place.
51
• Remove the circlip (27) holding the bearing bracket (29) in place.
54
• Pull off the bearing cage (29) using a puller.
Service Manual
https://www.forkliftpdfmanuals.com/
REFLEX RR B/E, RR B/E CC
T-code
403-414, 669-671, 716-718
Date
2005-06-01
13- 5