BT REFLEX RR B Service Manual page 233

© BT Europe AB
Electronic card – 5710
Parameter setting of all parameters
Valid from serial number
713962-
Order number
218920-040
24.5.25 Parameter 38
• Set this parameter to 1.
• Switch off the truck and then switch it on.
Calibration of the travel speed and brake potentiometers will take
place.
This parameter is automatically reset to 0.
NOTE:
Incorrect calibration.
Incorrect calibration value.
Do not operate the controls once calibration has started.
• Fully retract the reach carriage to the inner stop against the battery
wall.
• Fully extend the reach carriage to the outer stop.
The end position of the reach carriage cylinder and the slowdown dis-
tance have now been calibrated. During calibration, the reach carriage
speed is reduced.
• Set this parameter to 4.
• Switch off the truck and then switch it on.
Calibration of weight measurement is now possible.
• Set the forks in the free lift area and do not move them. (--- 1) is dis-
played
• To confirm the selection, keep the travel direction selector pushed in
the fork direction for two seconds and proceed to the next step.
• Now set the forks to the main lift area and do not move them. (--- 2)
is displayed
• To confirm, keep the travel direction pressed for two seconds.
• Lift the load (with the programmed weight) with the forks off the
ground in the free lift area. (-- weight) is displayed.
• Confirm by pressing the travel direction selector for two seconds.
Weight calibration is now complete and the weight symbol lights with a
steady light, while the weight is indicated in the display.
If an error occurs during programming, (Error) is displayed and pro-
gramming must be repeated.
Service Manual
https://www.forkliftpdfmanuals.com/
REFLEX RR B/E, RR B/E CC
T-code
403-414, 669-671, 716-718
Date
2005-06-01
24- 21