BT REFLEX RR B Service Manual page 453

© BT Europe AB
Positioning equipment – 9390
Automatic driving
Valid from serial number
713962-
Order number
218920-040
41.10 Automatic driving
There are two different automatic operating modes. One where the
forks are raised/lowered to the required level without a load and the oth-
er, with a load.
41.10.1 Collect load
• State the required height level using buttons 0-9 (e.g. 1+2=level 12).
The display shows LE12.
• Raise/lower the forks until they are automatically stopped by the
electronics. If the wrong direction is chosen, no "lift/lower move-
ment" will take place. The electronics expect the correct direction to
be selected.
• When the forks stop and the COLLECT LED comes on, the forks
can be manoeuvred under the load.
NOTE!
Forks not horizontal.
The load may slide off the forks or catch on the rack.
The forks must always be horizontal, particularly when the load is be-
ing deposited on or collected from the rack.
• Raise the forks until they are automatically stopped by the electron-
ics and the LEAVE LED comes on.
• Move the load from the rack. When the work cycle has been com-
pleted, the LEDs will go out.
Service Manual
https://www.forkliftpdfmanuals.com/
REFLEX RR B,E RR B,E CC
T-code
403-414, 669-671, 716-718
Date
2005-06-01
41- 11