BT REFLEX RR B Service Manual page 109

© BT Europe AB
Electric drive motor – 1760
Bearing replacement
Valid from serial number
713962-
Order number
218920-040
12.4.3 Assembling
Ensure all parts are intact and clean before re-assembly.
N-side
• Press the bearing (5) on the rotor axle.
• Replace the bearing cap (8) on the motor axle.
• Install the flange ring (17).
• Refit the washer (18) and circlip (16).
• Screw the bearing cap (8) and shield (3) together using the screws
(34) to a torque of 6 Nm.
• Fit the insulation hose on the sensor bearing cable.
• Place the terminal block (10) between the shields.
• Tighten the stud bolts (20) to a torque of 5 Nm.
• Tie the cables for the thermocontact and the sensor bearing to the
middle power cable.
D-side
• Install a gasket (30) on the bearing housing (29).
• Press the bearing (28) into the bearing housing.
• Fit the circlip (26).
Service Manual
https://www.forkliftpdfmanuals.com/
REFLEX RR B/E, RR B/E CC
T-code
403-414, 669-671, 716-718
Date
2005-06-01
12- 5