BT REFLEX RR B Service Manual page 53

1
© BT Europe AB
Introduction, maintenance – P1
Cab tilting
Valid from serial number
713962-
Order number
218920-040
WARNING!
Falling cab!
The cab can fall without dampening when tilted over 45°.
The cab is heavy so make sure the person catching it has the situa-
tion under control. If possible, use an overhead crane.
• Remove the two screws on the roof, position tool 31-150030 over
these and secure it using the screws
• Take hold of the handle and tilt the cab up fully.
• Insert the safety pin into the cylinder.
WARNING!
Risk of being crushed.
There is a great risk of injury if anyone is present in the motor com-
partment when tilting the cab back.
The safety pin must always be inserted.
Ensure nobody is present in the motor compartment when tilting the
cab back.
WARNING!
Risk of being crushed.
There is a great risk of injury if anyone is present in the motor com-
partment when tilting the cab back.
Ensure no one is in the motor compartment when tilting the cab.
• Take hold of the tool and tilt the cab back to the 45° position.
• Remove the tilt tool from the roof and replace the screws.
• Move the hydraulic lever for fork lift forwards until the cab comes to
rest in the lowered position.
NOTE!
Risk of being crushed.
The plastic guard can be damaged when tilting the cab down.
Always have the doorplate swung out when lowering the cab.
• Close the doorplate and tighten the screw for door locking.
• Dismantle the tool from the door.
WARNING!
Risk of tipping.
The truck can tip if the battery is removed when the truck is tilted to
the service position.
Never remove the battery from the truck.
Service Manual
https://www.forkliftpdfmanuals.com/
REFLEX RR B,E RR B,E CC
T-code
403-414, 669-671, 716-718
Date
2005-06-01
4- 7