BT REFLEX RR B Service Manual page 347

© BT Europe AB
Free lift cylinder – 6620
Assembling the cylinder
Valid from serial number
713962-
Order number
218920-040
31.7 Assembling the cylinder
• Position the assembly sleeve 08-15365 on the cylinder.
• Insert the rod in the cylinder.
• Remove the assembly sleeve.
• Knock the top sleeve (2) into position on the rod using a rubber
mallet.
• Screw the top sleeve (2) in the cylinder a few turns.
• Apply flange sealant FD 1042 on the thread.
• Tighten using hook spanner 08-15391.
NOTE!
The curing time for the flange sealant is 4 hours and the cylinders
must not be used before this.
31.8 Assembly
• Secure a lifting strap around the free lift chain bracket by the end of
the free lift piston and a lifting strap around the free lift cylinder (see
diagram).
• Lift up the free lift cylinder into its correct position.
• Fit the free lift cylinder using its mounting bolts.
• Take away the overhead crane.
• Fit the chain adjuster.
• Fit the free lift chain with its pin.
• Fit the split pin.
• Fit chain guard, if applicable.
• Remove the straps from around the free lift chain.
• Lift up the inner guide using an overhead crane.
• Place the twin hose and the cable on the free lift cylinder's hose
reels.
• Take away the overhead crane.
• Remove the plugs on the free lift cylinder.
• Fit the feeder pipe on the free lift cylinder.
• Fit the venting hose
Service Manual
https://www.forkliftpdfmanuals.com/
REFLEX RR B,E RR B,E CC
T-code
403-414, 669-671, 716-718
Date
2005-06-01
31- 5