Repairs; Replacing The Drive Shaft Sealing Ring; Dismantling - BT REFLEX RR B Service Manual

© BT Europe AB
Mechanical drive gear unit – 2550

Repairs

Valid from serial number
713962-
Order number
218920-040
13.5 Repairs

13.5.1 Replacing the drive shaft sealing ring

Replacing the drive shaft sealing ring is easiest when the drive assem-
bly is removed from the truck.
Follow the instructions below if oil leaks from the drive shaft.

Dismantling

• Remove the drive assembly from the truck as described in the sec-
tion "Replacing the drive motor/drive transmission".
• Remove the lower transmission cowl (2) and drain the oil.
• Loosen the drive shaft nut.
Remove the nut and spacer ring.
• Carefully tap out the drive shaft using a hammer and brass drift.
• Pull off the bearing from the drive shaft using tool 08-13022.
NOTE!
A standard claw puller cannot be used to remove the bearing.
Use a puller such as a KUKKO bearing puller.
• Check whether the spacer washers (6) on the bearing are damaged.
If the puller damaged them, measure the spacer washers' combined
thickness and replace them before assembling.
• Remove the sealing ring (7) from the drive shaft.
7 6
5
Service Manual
https://www.forkliftpdfmanuals.com/
4
REFLEX RR B/E, RR B/E CC
T-code
403-414, 669-671, 716-718
Date
2005-06-01
3
13- 9
2