BT REFLEX RR B Service Manual page 329

A
© BT Europe AB
Hydraulics – 6000
Adjusting the maximum lifting capacity
Valid from serial number
713962-
Order number
218920-040
26.5 Adjusting the maximum lifting
capacity
The hydraulic system must be run warm for approx. 10 minutes when
adjusting the maximum lift capacity so that the correct value is
obtained.
• Extend the reach carriage.
• Lower the forks to floor level.
• Remove the seal on the adjuster screw (A).
• Load the forks with the maximum weight.
Model
RR B/E1-B/E3
RR B/E1-B/E2
RR B/E3 (Side shift standard)
RR B/E4-B/E6
RR B/E4-B/E6 Side shift
RR B7-B8 (side shift standard)
The right lift capacity is achieved when the inner guide stops just above
B free lift, approx. 10 mm.
• Lower the forks to floor level.
Adjust to the right lift capacity using the adjuster screw (A) on the main
valve.
A = Flow regulation for fork lifting.
B = Flow regulation for fork lowering.
• Loosen the locking nut.
• Screw the adjuster screw (A) outwards to increase the flow.
• Screw the adjuster screw (A) inwards to reduce the flow.
• Lock the locking nut.
Seal the adjuster screw (A).
Service Manual
https://www.forkliftpdfmanuals.com/
REFLEX RR B,E RR B,E CC
T-code
403-414, 669-671, 716-718
Date
2005-06-01
Min. (kg) Max. (kg)
1600 1920
1475 1770
1475 1770
2000 2400
1875 2250
2500 3000
26- 13