BT REFLEX RR B Service Manual page 364

34- 4
Tilt cylinder – 6660.2
Refitting the cylinder in the truck
T-code
409-414, 669-671
Date
2005-06-01
34.4 Refitting the cylinder in the truck
• Assemble the bracket on the cylinder.
• Fit the hydraulic hose.
• Screw the cylinder bracket to the battery compartment wall.
• Remove the plug on the return hose and secure the return hose on
the tank.
• Press the switch (1) to lower the cab while at the same time turning
the key. The display shows 6 lines.
• Move the hydraulic lever for raising the forks back until the cylinder
is fully extended.
• Fit the safety pin in the cylinder piston.
• Secure the cylinder to the top of the cab.
• Move back the top section (45 degrees).
WARNING
Risk of being crushed.
There is a great risk of injury if the cab tilt cylinder has full oil pres-
sure when the top section is tipped back.
Ensure that the cab tilt cylinder is pressurised.
• Close the door and lock the door.
• Shift the fork lifting hydraulic lever forwards until the cab stops in its
lowest position.
WARNING
Risk of being crushed.
There is a great risk of injury if anyone is present in the motor com-
partment when tilting the cab back.
Ensure nobody is present in the motor compartment when tilting.
Service Manual REFLEX RR B/E, RR B/E CC
https://www.forkliftpdfmanuals.com/
Valid from serial number
713962-
Order number
218920-040
© BT Europe AB