BT REFLEX RR B Service Manual page 309

© BT Europe AB
Electronic card – 5710
Error Codes
Valid from serial number
713962-
Order number
218920-040
Code
Description
Error mode
Error cause
Comments
Main contactor, K10
1. If you forget to switch off the truck and pull out the charging
plug an error code is given.
2. Check that no extra equipment overloads the electrical sys-
tem.
3. Check that there is 48 VDC on input 808, cable 23 when K10 is
activated. If not, check the fuse F62 (10 A), contactor points on
K10 and the cables 1, 8 and 23.
4. If this does not help, replace A2.
5. Replace A5.
Service Manual
https://www.forkliftpdfmanuals.com/
231 - 232
Too low voltage on lift regulator
Lift regulator error
1. Faulty wiring/fuse F62
2. External current load incorrectly connected
3. Charger plug removed with ignition key switched
on
4. Defective electronic card A5
5. Defective lift regulator, A2
REFLEX RR B/E, RR B/E CC
T-code
403-414, 669-671, 716-718
Date
2005-06-01
24- 97