BT REFLEX RR B Service Manual page 362

34- 2
Tilt cylinder – 6660.2
Dismantling and assembling the cylinder
T-code
409-414, 669-671
Date
2005-06-01
34.3 Dismantling and assembling the
cylinder
34.3.1 Dismantling the cylinder
• Place the bottom stud in a vice and let the top section of the cylinder
tube rest against a support so that the cylinder lies in the horizontal
position.
NOTE!
The cylinder only needs to be locked so that it does not rotate during
subsequent work.
If you tighten too hard the cylinder tube can be deformed.
• Dismantle the link rod from the cylinder ram.
• Carefully knock the top sleeve with a rubber mallet.
• Unscrew the top sleeve using a hook spanner.
• Pull off the top sleeve from the rod and carefully remove the ram
from the cylinder tube. Place the rod on a soft and clean surface so
that it is not damaged.
• Brush off any old flange sealant from the cylinder tube and the top
sleeve.
34.3.2 Dismantle the seals and the support
ring
• Dismantle the wiper from the top sleeve.
• Use a screwdriver to dismantle the rod seal from the top sleeve.
• Remove the O-ring from the top sleeve.
• Remove the support ring from the rod.
Service Manual REFLEX RR B/E, RR B/E CC
https://www.forkliftpdfmanuals.com/
Valid from serial number
713962-
Order number
218920-040
© BT Europe AB