BT REFLEX RR B Service Manual page 390

37- 6
Lifting devices – 7400
Fork spread unit
T-code
403-414, 669-671, 716-718
Date
2005-06-01
37.3 Fork spread unit
37.3.1 Servicing of fork spread unit
For ordinary servicing of the truck, the following points must be
checked/implemented:
• Lubrication of friction plates against fork and ball beam
• Force grease into grease nipples when servicing the truck. The
brass bushings in the fork sleeve and in the support rollers provide
some degree of lubrication, as they are equipped with graphite inlay.
• Use graphite-type grease, Q8 Rembrandt EP2, for lubrication.
• Check bearings and axles. Replace worn parts with substantial play
in the fork sleeve. If the upper chromed axle has been damaged, this
must be replaced immediately. Wear on lower support rollers is the
result of the forks being used a lot for lateral conveyance. In very
dirty environments, these should be checked more often than in nor-
mal environments.
• Check forks. Wear must not exceed 10% of nominal thickness as
per ISO 5057
• Check screws and nuts. Tighten as normal, if required.
Service Manual REFLEX RR B,E RR B,E CC
https://www.forkliftpdfmanuals.com/
Valid from serial number
713962-
Order number
218920-040
© BT Europe AB