BT REFLEX RR B Service Manual page 438

39- 16
Control/computer equipment – 8700
Installation
T-code
403-414, 669-671, 716-718
Date
2005-06-01
39.12 Installation
NOTE!
Installation of the program must take place from the hard disk.
You must also be administrator with full privilege.
NOTE!
The software may be damaged in the computer and therefore installa-
tion on the PC must be implemented by a person with the necessary
knowledge.
BT is exempt from all responsibility for any faults resulting from in-
stallation.
NOTE!
All references to the PC operating system functions, menus and com-
mands are based on the English Windows® version.
39.12.1 Installation on a PC with Windows XP/
2000/NT
The software application is supplied on a CD or via a network in ZIP-for-
mat.
Extract the file and put it on the computer's harddrive.
Start the installation by running X:\SETUP.EXE, where X:\ is the drive
on which the installation application can be found.
Then follow the on-screen instructions.
39.12.2 IInstallation on a PC with Windows 95/
98
If truckCom has been previously installed on the PC, changes must be
made in the System. ini file.
Start the Msconfig.exe Start | Run msconfig program.
Click on System.ini and open the folder (386Enh).
Click away the tick for Device=C:WINDOS\Cpcppvd.vxd
Save and close the program.
Now start the installation
The program is supplied on CD or over the network and the installation
is started by running X:\SETUP.EXE, X = the program location.
Then follow the on-screen instructions.
Service Manual REFLEX RR B/E, RR B/E CC
https://www.forkliftpdfmanuals.com/
Valid from serial number
713962-
Order number
218920-040
© BT Europe AB