BT REFLEX RR B Service Manual page 255

© BT Europe AB
Electronic card – 5710
Warning Codes without registration
Valid from serial number
713962-
Order number
218920-040
Code
Description
Error mode
Error cause
Comments
Drive motor's pulse transducer bearing, U11
1. Check the cables to U11.
- Remove connection X27.
- Check that cable 11 is intact between X27 and terminal 4 on A1.
- Check that cable 10 is intact between X27 and terminal 3 on A1.
- Check that cable 12 is intact between X27 and terminal 5 on A1.
- Check that cable 13 is intact between X27 and terminal 6 on A1.
- Also check the connector pins on the terminals for play and oxidi-
sation.
- If the cables are okay, replace the transducer bearing U11.
2. If the fault remains, replace A1
Service Manual
https://www.forkliftpdfmanuals.com/
43
Incorrect number of pulses from the drive motor's
pulse transducer bearing
General error
1. Faulty sensor/wiring.
2. Defective drive regulator.
REFLEX RR B/E, RR B/E CC
T-code
403-414, 669-671, 716-718
Date
2005-06-01
24- 43