Steering Angle Sensor - 4350; General; Procedure - BT REFLEX RR B Service Manual

© BT Europe AB
Steering angle sensor – 4350

General

Valid from serial number
713962-
Order number
218920-040
20- Steering angle sensor – 4350
20.1 General
These instructions apply to adjustment of the steering angle sensor
mounted on the driving gear.

20.2 Procedure

The information supplied by the two directional arrows in the display
changes as the sensor detects a change between the high and low lev-
el in the driving gear.
The two-way sensor uses the gear wheel to calculate the steering
angle and displays the value in the display's compass rose.
NOTE:
The sensor may be damaged if it is adjusted against an incorrect sur-
face.
Always adjust the sensor against the upper surface.
20.1 Adjustment of directional sensor
Adjust the sensor to a detection range of 1 mm.
• Screw the sensor onto the machined surface until the two touch
each other.
• Then unscrew one full rotation.
• Verify that the LED on the sensor/electronic card lights when it is in
front of the machined surface.
1 mm
Service Manual
https://www.forkliftpdfmanuals.com/
REFLEX RR B/E, RR B/E CC
T-code
403-414, 669-671, 716-718
Date
2005-06-01
20- 1