Cab Heating/Ventilation - 0630; General; Air Conditioning Unit; Ventilation - BT REFLEX RR B Service Manual

P P
3 1 2
4 6
2
6
1
5
1m
LED
© BT Europe AB
Cab heating/ventilation – 0630

General

Valid from serial number
713962-
Order number
218920-040
8- Cab heating/ventilation – 0630
8.1 General

8.2 Air conditioning unit

In order to achieve the greatest possible operator comfort the ventila-
tion and heat can be adjusted to suit your requirements.

8.2.1 Ventilation

The fan can be set to three different speeds.
• Turn the control knob (3) to the required position.

8.2.2 Main heater

• Turn the control knob (2) to 1 to start the heater.

8.2.3 Auxiliary heater

Extra heat may be required when starting a cold truck and when driving
between cold and warm areas.
• Press the button (1) and the heater will give off heat under approx. 7
minutes, after which the heater will be turned off. Press once again if
4
you wish to restart the heater. The LED on the pushbutton/time relay
is lit when the extra heater is connected.
The time can be adjusted on the time relay inside the heater.
• The interval is adjusted using switch 5.
8 • The time is adjusted using knob 6.
10
The higher the fan speed, the greater the amount of hot air
provided in the cab.

8.2.4 Temperature

The temperature can be set from approximately 5 to 30 degrees, using
the thermostat (4).
• Set desired temperature in the cabin using the thermostat (4).
Service Manual
https://www.forkliftpdfmanuals.com/
REFLEX RR B/E, RR B/E CC
T-code
669-671, 716-718
Date
2005-06-01
8- 1