FX-1/FX-1R Maintenance Manual
3-2-3. Amplifier
See Subsection 4-4-3 "HMS offset" and Section 3-5 of MS Parameter manual.
3-2-4. Assembling the Fiber Unit to the Amplifier
Make the projection on the fiber unit facing toward a position where the LED does not exist on the
amplifier and insert it completely until it is in contact with the far side.
After the fiber has been inserted until it is in contact with the far side, turn the connector clockwise to
check that the fiber unit cannot be removed.
3-2-5. Setting the Switches on the Bad Mark Sensor Assembly
Use the bad mark sensor assembly with the settings made before shipment from the factory (default
settings).
Figure 3-2-2 Mounting the Amplifier
Fiber unit
Projection
Figure 3-2-3 Assembling the Fiber Unit
Output timer
Operation mode
selector switch
selector switch
→ NORMAL
→ L ON
Figure 3-2-4 Switch Settings
Amplifier
Mode switch
→ AUTO
3-3
Camera bracket U
Bad mark
sensor amplifier
SEMS cap bolt
(× 2)
Rev. 2.00