Connecting Both Conference Call Partners - Auerswald COMpact 5200 Advanced Information

Important: To use this function on ISDN and system phones, the
function must be supported via a function key or via the menu by the
respective phone (optional, see manual for the phone).
Note: You also can use this function this function on analogue phones,
where it can be performed via the T-Net function key/menu (optional, see
manual for the phone).

Connecting Both Conference Call Partners

If you want to leave a conference call that you initiated yourself and your
conference call partners want to continue talking with each other, you can
connect both parties.
Requirements:
• A conference call that you initiated yourself
• To connect two external communication partners, the following is
required: Authorisation Transfert d'appels externes vers l'extérieur
assigned to the subscriber
During a conference call, proceed as follows:
1. Press the Flash key or the Query key.
2. Dial 4.
3. Hang up the receiver.
Both conference call partners are connected with each other.
COMpact 5200/5200R/5500R - Firmware V7.2 - Advanced Information V04 07/2018
Phoning
Conference Calls
281