Relays (Actuators) - Auerswald COMpact 5200 Advanced Information

Functions, Uses, Concepts

Relays (Actuators)

Relays (Actuators)
The PBX supports the connection and control of various types of relays. A
relay can be part of a connected door terminal or another connected device
(e. g. an IP switch relay). Relays can have various functions on the PBX. For
a detailed description of the operating modes, refer to the chapter
Functions, Uses, Concepts > Relays (Actuators) > Relay Operating Modes.
Note: The internal system relay with the identification number 900
(factory setting) has a special position. It can only be used in the
operating type automatic configuration switchover to switch it via phone
on or off. For this purpose, the relay is being switched on or off. For the
operation of standard phones see chapter Short Reference > Relay, for
system phones see manual of the phone.
Proceed as follows for configuration:
• Creating an IP switch relay.
– Using the Configuration Manager (page Périphériques > Assistant
de périphériques)
• Creating a relay.
– Using the Configuration Manager (page Périphériques > Relais
(actionneurs))
• Configuring the operating mode for the relays.
– Using the Configuration Manager (page Périphériques > Relais
(actionneurs))
• Configuring relays.
– Using the Configuration Manager (page Périphériques > Relais
(actionneurs) > Configurer)
154
COMpact 5200/5200R/5500R - Firmware V7.2 - Advanced Information V04 07/2018