Auerswald COMpact 5200 Advanced Information page 473

Transfert d'appel
GENERAL SETTINGS FOR CALL FORWARDING
Méthode de transfert d'appel
Call forwardings at the exchange line are configured and performed in
different ways. The exchange line, router or the provider determines which
of the call forwardings listed below can be used.
Installation CF

The call forwarding is controlled in the PTMP exchange line. The
standardized message processings are not supported by all providers.
Registre

Special form of the Keypad call forwarding method in Spain.
Installation CR

The call forwarding is controlled in the PTP connection. Not every
provider supports this method.
Clavier

The call forwarding is controlled in the PTMP exchange line. The digit
sequence depends on the provider or router.
CD facility

The call forwarding is controlled in the PTMP connection. Not every
provider supports this method.
2. B channel

The call forwarding is performed by the PBX during a call. It is possible
for all exchange line types but requires a free voice channel and the number
of the caller cannot be displayed unless CLIP no scrrening is used which is
COMpact 5200/5200R/5500R - Firmware V7.2 - Advanced Information V04 07/2018
Settings – Réseaux publics
Connexions RNIS
473