Tonalités
Tonalité 1 (tonalité normale)
Tonalité 2 (tonalité spéciale)
Tonalité 3 (tonalité Centrix)
Busy tone 1 (call target busy)
Busy tone 2 (network busy)
Tonalité d'appel 1
Tonalité d'appel 2
Tonalité d'intérêt spéciale
The character strings show which tones are sent by the analogue network
provider. This means the PBX can then identify the tones and apply them
accordingly.
The network provider uses these tones in the following situations:
•
Tonalité
When a subscriber picks up the call.
•
Busy signal
If the required connection is busy (busy signal 1), or if the network is
overloaded (busy signal 2, e.g. directly after dialling the local area
code).
•
Tonalité d'appel
During the call phase.
•
Tonalité d'intérêt spéciale
If the dialled phone number is not present, and the network provider has
not recorded a special announcement for this situation.
COMpact 5200/5200R/5500R - Firmware V7.2 - Advanced Information V04 07/2018
Settings – Réseaux publics
Connexions analogiques
435