Auerswald COMpact 5200 Advanced Information page 732

Settings – Périphériques
Assistant de périphériques
Configure IP Switch Relay
An existing IP switch relay can be connected to the PBX so that various
functions controled by the PBX (see chapter Functions, Uses, Concepts >
Relays (Actuators) > Relay Operating Modes) can be carried out. This IP
switch relay must be created in the configuration of the PBX.
The IP switch relay and the relays available for it can be created with the
device wizard. To control the relays, the PBX needs to know the IP address,
port, user name (optional) and password of the connected device (see
manual and settings of the device in question).
Various IP switch relays supported by the PBX are available as device
templates. They already include several default values for operation of the
IP switch relays in their factory settings.
If no of the device templates on offer matches your installation, you can
select a user-defined device template.
In addition, you can select a simplified device template (IPBox Simple)
which will make it easier for you to create an IP switch relay with the
operating mode Relais manuel.
732
COMpact 5200/5200R/5500R - Firmware V7.2 - Advanced Information V04 07/2018