Auerswald COMpact 5200 Advanced Information page 642

Settings – Groupes
Profils
Paramètres de base
Schéma de sonnerie après
Tous
All subscribers logged-in to the group will ring simultaneously. Selected
subscribers will start to ring after the configured delay time (après). If a call
was not accepted, although all logged-in members of the group were called,
the call would be finished with a busy signal.
Tous - groupe fractionné
The call is handled almost similar to the ringing sequence Tous. The only
difference is the way multiple calls to the group are handled: If the group
receives further calls during an active call, the group will be split into several
smaller groups ringing for a specific active call. But there will never ring
more calls in the group than the number of free available group members.
Additional calls will be rejected with a busy then. If a call is accepted the
other phones ringing so far for this call are assigned to the other pending
calls and will immediately start to ring again. If a group member finishes a
call, this subscriber will immediately ring again for the pending calls. The
timer for the configured delay time (après) starts after receiving the first call
to the group and will not restart for additional incoming calls.
Linéaire - fixe - groupe fractionné
Only the phone of one group member will ring. After the configured delay
time (après) another single group member will be called. The order of calls
depends on the configured Priorité. If a call was not accepted, although all
logged-in members of the group were called, the call would be finished with
a busy signal.
Linéaire - compensé - groupe fractionné
Only the phone of one group member will ring. After the configured delay
time (après) another single group member will be called. The order of the
calls depends on the configured Priorité: First of all the member of the
group first logged-in gets the position 1 in the order of calls, the second one
642
COMpact 5200/5200R/5500R - Firmware V7.2 - Advanced Information V04 07/2018