Auerswald COMpact 5200 Advanced Information page 271

Note: Some ISDN phones may ring after hanging up the receiver and
you may then be reconnected with your first communication partner after
picking up the receiver. Use the manual for the phone to check whether
the Transfer at a PBX function has been enabled. If this has not been
done, do this subsequently.
• If you want to initiate a new call immediately after the transfer, proceed
during the query call as follows.
a) Press the Flash key or the Query key.
b) Dial 4.
Both communication partners are connected with each other.
You will hear the internal dial tone.
c) Initiate a new call.
Important: A call transferred between two external communication
partners is limited to a defined period of time. This is a security feature,
since the transfer of the time announcement or of the weather forecast
made by mistake, for instance, would lead to a very long call.
You will be charged the fees for a transferred call by your network
provider.
Note:
You can also use this function on analogue phones, where it can be
performed via the T-Net function key/menu (optional, see manual for the
phone).
On some ISDN phones, this function can be called via an existing
function key or via the menu (optional, see manual for the phone).
COMpact 5200/5200R/5500R - Firmware V7.2 - Advanced Information V04 07/2018
Phoning
Transferring
271