Auerswald COMpact 5200 Advanced Information page 429


The PBX checks whether loop current is present on the line on which
the call is to be made.
Notes:
If loop current is detected, the line is used.
If no loop current is detected, the PBX treats the line as if it is either not
enabled or not present.
Début de l'appel (appels sortants)
Temps d'attente après composition du dernier chiffre (1-30 secondes)
The waiting time serves for post-dialling digits before the PBX recognises
that dialling has been finished and sends # to the exchange line. # signalises
the exchange line that the number sequence is completed.Time
measurement restarts after the entry of each digit. The possibilty of post-
dialling digits is not applicable if the PBX has recognized that the number
sequence is already completed and automatically sends # to the exchange
line.
Notes:
Select as short a time as possible, because the PBX does not forward
the last number to the public exchange until the specified time has
passed.
Approximately three seconds is the default value for manual inputs.
COMpact 5200/5200R/5500R - Firmware V7.2 - Advanced Information V04 07/2018
Settings – Réseaux publics
Connexions analogiques
429