Auerswald COMpact 5200 Advanced Information page 771

Loudspeaker Announcements
Commande d'arrêt
Requirements:
• Created relay

The PBX will switch off relays with the operating modes Light, Door
opener, Alarm and PC relay after the specified switching duration.

The hold time of the relay will be used. The PBX does not actively
switch off the relay.
Note: As a a pre-requisite, off control must be supported by the relay (for
some relays, e. g. the a/b Switching Modules, switching off cannot be
controlled).
Plages horaires
The switching duration of a relay specifies after how many seconds the PBX
will switch off the relay. Possible entries: 0 to 6000 (0 only for manual
relays).
Notes:
The switching duration is used for relays with the operating modes Light,
Door opener, Alarm, PC relay and Manual relay.
To enable the PBX to switch off the relay after the specified switching
duration, off control must be supported by the relay and be switched on
(for some relays, e. g. the a/b Switching Modules, switching off cannot
be controlled). Alternatively, the hold time of the relay can be used.
COMpact 5200/5200R/5500R - Firmware V7.2 - Advanced Information V04 07/2018
Settings – Périphériques
Relais (actionneurs)
771