Auerswald COMpact 5200 Advanced Information page 431

Fin d'appel
Reconnaissance de la tonalité occupée (appels entrants)
Reconnaissance de la tonalité occupée (appels sortants)

The PBX recognises the busy signal sent by the public exchange.
It needs this to identify that the call connection has finished and to automat-
ically disconnect an ISDN phone.
Note: Disable this setting if the PBX identifies disruptions on the external
line as the busy signal, because this would cause it to interrupt conver-
sations. In this situation, the subscriber must signal to the PBX that the
call is ended by disconnecting.
Longueur minimale de la tonalité occupée (3-20 secondes)
The minimum length of the busy signal specifies the time (in seconds) the
PBX takes to identify a busy signal sequence. This prevents, for example,
the PBX identifying speech as a busy signal.
Tonalité continue
Requirements:
• The PBX must recognise the continuous tone sent by the network
provider as the end of the call

The PBX recognises the continuous tone sent by the network provider
as the end of the call connection.
COMpact 5200/5200R/5500R - Firmware V7.2 - Advanced Information V04 07/2018
Settings – Réseaux publics
Connexions analogiques
431