Installation - NEC Univerge SV8100 System Hardware Manual

Issue 2.0
9 - 48
11.5.6

Installation

DO NOT install the NEC BackOffice Software
until instructed! It is critical that you follow the
steps in the installation procedure in the order
listed below. Failure to do so results in an
unsuccessful installation.
11.5.6.1 Location Preparation
The wiring for the extensions should be within six feet of
the PC location. For this reason, the PC for the NEC
BackOffice Recorder should be located near the MDF for
extension wiring.
The installer must prepare the wiring to tap off the digital
pair with a T-Connect type setup.
It may be desirable to fasten the devices to a PC or rack.
Since the devices are lightweight, this can be done quite
easily with Velcro tape.
11.5.6.2 Set Up PC


1.
DO NOT connect more than four of the 4-Port
Digital Call Logging Unit devices to each USB
Controller Card.
DO NOT connect more than two of the 16-Port
Digital Call Logging Unit devices to each USB
Controller Card.
Set up the PC with the appropriate number of USB
Controller Cards and/or USB hubs. Follow the
installation instructions for the Controller Card
carefully. The PC should be connected to the LAN
for supervisor access and to facilitate Windows and
software updates as needed. It may be desirable
also to load PC Anywhere on the PC for remote
administration of the application.
Installing SV8100 Optional Equipment
UNIVERGE SV8100