Figure 6-7 Connecting Base Unit To The Telephone Jack; Installation Precautions - NEC Univerge SV8100 System Hardware Manual

Hide thumbs Also See for Univerge SV8100:

Table of Contents

To ensure optimum performance follow these guidelines:

Base units must be placed at least 15 feet apart.

The base antenna should be vertical.

Always place the base unit on top of a desk or on higher shelves. Avoid

locations surrounded by metal surfaces.

Place the base away from any electrical component such as a PC, monitor,

or other telephone.

Connecting the Telephone Cords

When connecting the telephone cords, observe the following precautions:

Never install telephone wiring during a lightning storm.

Never touch bare telephone wires or terminals unless the telephone line is

disconnected at the network interface.

Use caution when installing or modifying telephone lines.

To connect the telephone cords:

Connect the cord from the telephone jack to the Base Unit LINE IN jack.

Figure 6-7 Connecting Base Unit to the Telephone Jack

Connect a qualified NEC digital multiline terminal to the LINE OUT jack.

UNIVERGE SV8100

Line in From

Telephone Jack

Installing SV8100 Cordless Telephones