Table 4-6 Cd-Cp00-Us Switch 6 Settings; Table 4-7 Cd-Cp00-Us Led Indications - NEC Univerge SV8100 System Hardware Manual

Issue 2.0
SW6-1
SW6-2
SW6-3
SW6-4
RUN (LED1)
4 - 22

Table 4-6 CD-CP00-US Switch 6 Settings

Configuration
ON
OFF
OFF
ON
3.1.4 LED Indications
The LEDs on the CD-CP00-US indicate the following:
RUN (LED 1) = The CPU is operating (green)

LED 2, and 3 = Alarms (red)

LED 4 = Flash access indication (red)

LED 5 = The USB memory connection status (red)

(LED off when no USB memory installed)
Refer to Program 90-10: System Alarm Setup for details on assigning

alarm LEDs.

Table 4-7 CD-CP00-US LED Indications

and associated operation and status indications. Refer to
CD-CP00-US Blade Layout on page 4-16
LEDs on the CD-CP00-US.
Table 4-7 CD-CP00-US LED Indications
LED Indication
LED2 LED3
Blinking Off
Off Off
Off On
Not Used
Test Mode
RS232C Select
Reset Configuration
LED4 LED5
Off Off On Steady When
USB Memory is
Installing
Off Off Blinking
Off Off
UNIVERGE SV8100
Note
ON = Test Mode
OFF = Normal
ON = Use
OFF = Not Used
ON = Normal
OFF = ICE Mode
provides a list of each LED
for the location of the
Status
System operating normally
Boot is starting
Off Initializing the disk or
formatting
Installing the SV8100 Blades
Figure 4-6